1、When the microphone is mounted on the camera or DSLR, screw the hot shoe holder of the device and fasten it clockwise, when the hot shoe is occupied or used by other device, please mount the bottom standard connecting nut on the microphone tripod.
2、Plug the Ø3.5 connector into the microphone socket (attention: should be inserted completely).
3、Windscreen: filter the impact of airflow to ensure the quality of vocal pick up.
Battery installation and remove
1、Battery installation: Figure:Unscrew the battery cover according to the "Unlock" direction on the battery cover, put the supplied button battery(CR2032) into the battery holder with correct polarity(put the side with symbol "+" upwards) and press it till it is fixed, the screw up the battery cover clockwise.
2、When remove the battery, push the metal buckle on the compartment outwards, the battery will pop up automatically.
√Transducer Principle: Back Electret Condenser
√Polar Pattern: Stereo/Cardioid X2
√Sensitivity: -42dB±3dB (0dB=1V/Pa at 1KHz)
√Frequency response: 30Hz-16KHz
√Low cut: 80Hz 10dB/octave
√Max.SPL: 120dB (THD≤1.0% at 1KHz)
√Power Requirement: 3V (CR2032 button battery)
About sensitivity switch
√-10dB : Suitable for noisy scenes
√+20dB : Suitable for recording louder sounds in quiet scenes
1 x RegeMoudal Camera Microphone for Nikon Canon Sony DSLR Camera (Need 3.5mm Interface)
1 x Windscreen
1 x Button Battery
1 x User Manual
1 x Cable
If this camera microphone is connected with your DSLR camera, the indicator LED will keep dark during recording. And if the indicator LED keep flash, it means the battery is too weak.